Roush9855
Registered user
Registered: 03-2011
Posts: 44
|
Reply | Quote
|
|
How do I repair a tear in latex?
Ok, so I have looked around and can't seem to find anything about this. I have a batman cowl that has a pretty long tear (not slit) on the back of it. I wan wondering how could I go about repairing the tear (I am assuming liquid latex) and make it where it will be durable enough to put it on without it tearing again. Another problem that I think I might run into is when I repair ir, how would I get that area the same color as the cowl? Any help would be appricated as I do not want to just throw out a nice cowl, or sell it. Thanks.
|
5/4/2011, 11:44 pm
|
Link to this post
Send Email to Roush9855
Send PM to Roush9855
Blog
|
resinsamurai
Registered user
Registered: 01-2009
Posts: 1130
|
Reply | Quote
|
|
Re: How do I repair a tear in latex?
photos of the damage?
it takes some effort to repair, and usually there are
some trade offs, meaning it may not be wearable again
but it depends on the amount of damage
--- And what’s ten years? Well, it’s roughly how long it takes to put in ten thousand hours of hard practice. Ten thousand hours is the magic number of greatness.
|
6/3/2011, 4:01 pm
|
Link to this post
Send Email to resinsamurai
Send PM to resinsamurai
|